MASSO
MASSO Documentation
Step 4: Setting homing direction
During homing if any of the axis starts moving away from the homing sensor/switch, press ESCAPE or feed
hold button to stop homing cycle and invert the direction in the homing setting as shown below.
In the Examples below the X axis homing direction has been inverted.
When inverting the homing direction of a slaved axis please make sure that both axis have the same
setting for axis that make up a slaved pair or they will travel in opposite directions.
v5.18 - 08 Apr,2021
www.masso.com.au Page 337 of 477
To Next Page
Loading...
