MIMAKI UJF-3042 - 2011 Mimaki Engineering Co.,Ltd

© 2011 MIMAKI ENGINEERING CO.,LTD. 4.3.3 R.2.0 P.2
4.3.3 Carriage Front/Rear Tilt Adjustment
1
2
3
4
5
6
7
8
 Adjustment procedure
Perform the following steps as follow-ups of the procedure previously described in ”Check for carriage Tilt”.
6. Remove the LED-UV Unit. (See6.7.1)
7. Loosen the screws located on the both sides of the carriage.
8. Insert a 1.5mm thickness gauge between the table and carriage
and adjust the height so that the right and left sides (near and far
sides) of the carriage have the equal height. After that, tighten
the screws that were loosened.
The measurement point and adjustment value are specified
in the step 5.
9. Perform the assembly by reversing the disassembly procedure.
Fixing screw of the Carriage Base
Both side of the carriage
 Since the carriage is relatively small, you can
check both the near and far sides together by
inserting a long thickness gauge into the far side.
Maintenance Manual > Adjustment > Mechanical Adjustment > Carriage Front/Rear Tilt Adjustment
Model UJF-3042/FX Issued 2010.08.27 Revised 2011.09.30 F/W ver 1.80 / 1.00 Remark
2.0
Rev.