MIMAKI UJF-3042 - 2011 Mimaki Engineering Co.,Ltd

© 2011 MIMAKI ENGINEERING CO.,LTD. 4.2.18 R.2.0 P.1
1
2
3
4
5
6
7
8
Maintenance Manual > Adjustment > Adjustment Items > Shot Count Reset
Model UJF-3042/FX Issued 2010.08.27 Revised 2011.09.30 F/W ver 1.80 / 1.00 Remark
2.0
Rev.
4.2.18 Shot Count Reset
 Outline
This section describes how to “reset the shot count” and “reset the offset value of the Head driving power voltage” of
selected head.
 Work Procedures
1. Select [#ADJUST] -> [RESET SHOT CNTS].
2. Select a head and set whether or not to reset, and then press
ENTER key.
[] / [] :Select head
[] / [] :Select whether or not to reset
Head to be reset: Displayed
Head not reset: Not displayed
[ENTER] : Confirm
[END] : Back
3. Determine whether you reset the offset voltage of the head
selected in the Step 2 or not.
[ENTER] : Reset it.
[END] : Not reset it.
 Use this menu when you replace the head.
FUNCTION
#ADJUST <ent>
#ADJUST
RESET SHOT CNTS<ent>
#RESET SHOT CNTS
HEAD [MCYKW
C
L
]
#RESET SHOT CNTS
HEAD [ YKW
C
L
]
#OFFSET VOLT
INITIAL.OK? <ent>