MIMAKI UJF-3042 - 2.3.8 3042 Slider Pcb Assy. 2.0 1; 2011 Mimaki Engineering Co.,Ltd

© 2011 MIMAKI ENGINEERING CO.,LTD. 2.3.8 R.2.0 P.1
1
2
3
4
5
6
7
8
Maintenance Manual > Electrical Parts > Circuit Board Specifications > 3042 Slider PCB Assy.
Model UJF-3042/FX Issued 2010.08.27 Revised 2011.09.30 F/W ver 1.80 / 1.00 Remark
2.0
Rev.
2.3.8 3042 Slider PCB Assy.
 Outline
Board name :3042 Slider PCB Assy.
Mounted position :Carriage
 Main specifications
This PCB controls three print heads, LED-UV and other IOs.
 List of Connectors
* For the details of connecting destinations, refer to the block dia-
gram.
Print Head control Available up to three (6 nozzle lines)
LED-UV control Controls the maximum of two UVLED-DRIVE PCBs.
Y-origin sensor Origin sensor of the carriage.
Linear encoder signal Enters the encoder PCB signal.
Other IO It is equipped with the multipurpose IO.
Parts No. Pin Connected to:* Connecting
destination CN
Remarks
CN1 16 3042 Slider Relay PCB Assy CN5 3042 Slider Relay PCB&3042 Slider PCB
Serializer I/F
CN2 30 3042 Slider Relay PCB Assy CN3 HDC IO
CN3 3 IPPR3_Cascade short 13 Assy Short pin
CN4 30 3042 Slider Relay PCB Assy CN7 GND & etc
CN5 9 Not Use JTAG I/F (CPLD writing and FPGA JTAG TEST)
CN6 30 3042 Slider Relay PCB Assy CN8 “COM” Wave I/F
CN7 50 Print Head (EVEN) Head control 1
CN8 50 Print Head (ODD) Head control 1
CN9 50 Print Head (EVEN) Head control 2
CN10 50 Print Head (ODD) Head control 2
CN11 50 Print Head (EVEN) Head control 3
CN12 50 Print Head (ODD) Head control 3
CN13 50 Not Use Connector is not mounted
CN14 50 Not Use Connector is not mounted
CN15 22 LEDUVx2-DRIVE PCB
Thermistor1
Thermistor2
CN1
TH
TH
LED-UV Control
Connects with the thermistor 1 on the UVLED PCB.
Connects with the thermistor 2 on the UVLED PCB.
CN16 16 Not Use 16 Pin SERIAL I/O
CN17 8 LED Pointer
Mist Absorption FAN
UVDRV cooling FAN
Use for LED pointer
5V Axial flow FAN
5V Axial flow FAN
CN18 10 Not Use General-purpose io
CN19 7 Y-origin sensor
Encorder PCB Assy CN1
Origin sensor for slider. (OJ-6505-N2)
Reading signal from Encorder PCB.
CN20 4 Not Use General-purpose analog input.