MIMAKI UJF-3042 - 2011 Mimaki Engineering Co.,Ltd

© 2011 MIMAKI ENGINEERING CO.,LTD. 6.2.1 R.2.0 P.3
6.2.1 Head Assy
1
2
3
4
5
6
7
8
 Procedures of Disassembly and Reassembly
1. Turn the main power OFF
2. Disconnect the FPCof the Print Head from the Head Slider
PCB.
3. Remome the screw of Dumper Cover.
Screw : P3x6SMW x1
4. Remome the Dumper & Dumper Cover.
As shown in the lower right figure, the Dumper Cover is
attached by inserting the tab. Tilt and remove the tab with care
not to damage the Dumber or Tube.
5. Remome the Air Bleeder Tube.
1), Remome the screw of Fitting Cover.
Screw : B3x6 x1
2)Loosen the nut on the back of the Air Bleeder BKT (lower
right figure) and remove the Tube.
6. Remove the two screws that fix the Head.
Use a slotted screwdriver.
7. Remove the Head Assy.
(with the GEN Head Holder (metal plate) attached)
Screw
Tab
Dumper &
Dumper Cover
Fitting Cover
Air Bleeder Tube
Air Bleeder BKT
Nut
Head fixing screw
Head Assy
GEN Head
Holder
Maintenance Manual > Disassembly and Reassembly > Ink-related Parts > Head Assy
Model UJF-3042/FX Issued 2010.08.27 Revised 2011.09.30 F/W ver --- Remark
2.0
Rev.