MIMAKI UJF-3042 - 2011 Mimaki Engineering Co.,Ltd

© 2011 MIMAKI ENGINEERING CO.,LTD. 6.2.8 R.2.0 P.2
6.2.8 Capping
1
2
3
4
5
6
7
8
5. Remove the Cap Slider.
(1) Remove the Cap Slider from the guide flute by extending
the side surface of the Cap Base.
(2) Take two springs off.
 Method to disassemble by units of part such as cap rubber
1. Pull out the tube from the cap from the fitting.
2. Remove the Cap Cover.
• Screw x5
3. Perform maintenance on each part and replace it.
Cap Slider
Tube from cap
Cap Cover
Cap Rubber
Cap spring
Maintenance Manual > Disassembly and Reassembly > Ink-related Parts > Capping
Model UJF-3042/FX Issued 2010.08.27 Revised 2011.09.30 F/W ver --- Remark
2.0
Rev.