MIMAKI UJF-3042 - 2011 Mimaki Engineering Co.,Ltd

© 2011 MIMAKI ENGINEERING CO.,LTD. 6.4.9 R.2.0 P.1
1
2
3
4
5
6
7
8
Maintenance Manual > Disassembly and Reassembly > PCBs > Linear Encoder PCB
Model UJF-3042/FX Issued 2010.08.27 Revised 2011.09.30 F/W ver --- Remark
2.0
Rev.
6.4.9 Linear Encoder PCB
 Procedures
1. Turn the main power OFF.
2. Remove the following covers:
• Front Cover
• Upper Cover
• Head Cover
• Slider PCB Cover
3. Remove the L-Sensor BKT together with the PCB.
4. Remove the Linear Encoder PCB Assy..
5. Reverse the disassembly procedure for reassembly.
To turn power off, be sure to turn the main power OFF.
Linear Encoder PCB Assy.
L-Sensor BKT
Linear Encoder PCB Assy.
L-Sensor BKT
Linear Encoder PCB
Assy.
 When the encoder is assembled, adjust the up/
down and front/back position of encoder surely
not to contact to the scale.
1~1.5 mm
Encoder Scale
Encoder
Set to the center as far
as possible.