MIMAKI UJF-3042 - 2011 Mimaki Engineering Co.,Ltd

© 2011 MIMAKI ENGINEERING CO.,LTD. 6.7.1 R.2.0 P.1
1
2
3
4
5
6
7
8
Maintenance Manual > Disassembly and Reassembly > UV Parts > LED UV UNIT
Model UJF-3042/FX Issued 2010.08.27 Revised 2011.09.30 F/W ver --- Remark
2.0
Rev.
6.7.1 LED UV UNIT
 The LED-UV UNIT “New Type” explained here has no compatibility with the “Old Type” as indi-
cated below. “New Type” indicated by this version is the one whose design has been changed in con-
sideration of ease of maintenance and individually replaceable part. Do not divert parts indicated by
this version to the LED-UV UNIT of “Old Type”.
 When the UVLED PCB is required to be replaced due to illuminance deterioration etc., replace
“LEDUV Irradiation Assy” of the figure below. Replacement of UVLED PCB only is forbidden
strictly.
After illuminance and operation were checked in the factory, and the one whose performance
could be secured is provided as the maintenance parts. Therefore, it is prohibited to use parts
that were disassembled and assembled in the field again.
LED UV UNIT
Old Type
No connector on the top surface.
New Type
Connector can be con-
nected on the top surface.
LEDUV Irradiation Assy