© 2011 MIMAKI ENGINEERING CO.,LTD. 4.2.2 R.2.0 P.7
4.2.2 HEAD ADJUST
1
2
3
4
5
6
7
8
Procedures of Head Back/Forth Adjustment
1. Set Media at X-origin.
2. Display [#ADJUST] -> [HEAD ADJUST] -> [POSITION
ADJUST].
3. Select either of the pattern 1 or the pattern 2.
4. Press the [ENTER] key to draw the pattern.
[ENTER]: To start Pattern drawing
[][][][] :To start Jog mode (move the drawing origin)
5. Check if the space of pattern 1 is in compliance with the specifi-
cation.
Specified value: head 1-2 : 0 ± 10 µm
head 1-3 : 254 ± 10 µm
(The space of each head shall be according to
the value shown in the left figure.)
• *If the pattern is out of the specification, execute the Head
back/forth adjustment (refer to Page8).
FUNCTION
#ADJUST <ent>
#ADJUST
HEAD ADJUST <ent>
#HEAD ADJUST
POSITION ADJUST <ent>
#POSITION ADJUST
PATTERN : pattern1
SLANT ADJUST <ent>
pattern2
#POSITION ADJUST
PRINT START :ent
Set the drawing origin as follows;
(Set in [LOCAL] -> [ORIGIN])
X ≥ 0, Y > 0
head 1
head 2
Specified value:
0±10µm
If the adjustment with [SLANT ADJUST] or [POSI-
TION ADJUST] is executed, check them again from
the beginning then repeat this process until any
adjustment is not required on both.
Maintenance Manual > Adjustment > Adjustment Items > HEAD ADJUST
Model UJF-3042/FX Issued 2010.08.27 Revised 2011.09.30 F/W ver 1.80 / 1.00 Remark
2.0
To Next Page
Loading...
