MIMAKI UJF-3042 - 2011 Mimaki Engineering Co.,Ltd

© 2011 MIMAKI ENGINEERING CO.,LTD. 6.1.3 R.2.0 P.3
6.1.3 “Tube_FFC Holder” Stick the Protection tape
1
2
3
4
5
6
7
8
8. Take the Ink Tubes off from the “Tube_FFC Holder”
9. Remove the “Tube_FFC Holder”.
• Fixing Screw x2
10. Stick the Protection tape on the “Tube_FFC Holder”.
• Recommended tape: Acetate fiber tape of 40mm width
11. Reverse the disassembly procedure for reassembly.
Tube_FFC Holder
Protection tape
 Method and note for pasting tape are as below:
Paste tape so that
the screw to fix the
tube holder (TM-
04) can be screened
out.
Do not seal holes.
Tape width: 40mm
Maintenance Manual > Disassembly and Reassembly > Covers > “Tube_FFC Holder” Stick the Protection tape
Model UJF-3042/FX Issued 2010.08.27 Revised 2011.09.30 F/W ver --- Remark
2.0
Rev.