MIMAKI UJF-3042 - 2011 Mimaki Engineering Co.,Ltd

© 2011 MIMAKI ENGINEERING CO.,LTD. 6.2.2 R.2.0 P.1
1
2
3
4
5
6
7
8
Maintenance Manual > Disassembly and Reassembly > Ink-related Parts > Dumper
Model UJF-3042/FX Issued 2010.08.27 Revised 2011.09.30 F/W ver --- Remark
2.0
Rev.
6.2.2 Dumper
 Procedures
1. Turn the main power OFF.
2. Remove the Head FPC of the target Head from the Slider PCB.
3. Remove the Cap Nut, and pull of the Ink Tube.
4. Remome the screw of Dumper Cover.
Screw : P3x6SMW x1
5. Remome the Dumper & Dumper Cover.
As shown in the lower right figure, the Dumper Cover is
attached by inserting the tab. Tilt and remove the tab with care
not to damage the Dumber or Tube.
 To turn power off, be sure to turn the main power OFF.
 Be sure to wear Protective Glasses and Working Gloves during the work operation.Ink may get in
your eyes depending on the working condition, or hand skin may get rough if you touch the ink.
 Be sure to start the work after confirming the working process.
(Refer to “3.1.2 Replacement of Dumper”)
 Spread the media or the like around the Carriage not to soil the surroundings.
Dumper Cover
Dumper
O Ring
Tube
Cap Nut
Take care not to stain any object by ink dripping.
Tab
Dumper &
Dumper Cover