MIMAKI UJF-3042 - 2011 Mimaki Engineering Co.,Ltd

© 2011 MIMAKI ENGINEERING CO.,LTD. 6.3.3 R.2.0 P.1
1
2
3
4
5
6
7
8
Maintenance Manual > Disassembly and Reassembly > Driving Parts > Table
Model UJF-3042/FX Issued 2010.08.27 Revised 2011.09.30 F/W ver --- Remark
2.0
Rev.
6.3.3 Table
 Procedures
1. Make a printer the next state.
1), Move the Y-Bar to the farthest position.
2), Move the Carriage to the capping position.
3), Raise the Table to the highest position.
2. Turn the main power OFF.
3. Remove the following covers.
• Front Cover
•Rear Cover-TB (See left figure)
4. Disconnect the relay connector of the Suction fan Assy .
To turn power off, be sure to turn the main power OFF.
Table
Rear Cover-TB
Screw two positions
Rear side of machine
Relay connector of the Suction fan Assy