MIMAKI UJF-3042 - 2011 Mimaki Engineering Co.,Ltd

© 2011 MIMAKI ENGINEERING CO.,LTD. 4.3.4 R.2.0 P.2
4.3.4 LED-UV Unit Height Adjustment
1
2
3
4
5
6
7
8
 Adjustment procedure
Perform the following steps as follow-ups of the procedure previously described in”Check the Height of LED-UV
Unit” .
6. Loosen the Fixing screw of LED-UV Unit.
7. Adjust the gap between the LED-UV Unit and the upper surface
of the table so that it settles within the specified range. After
that, tighten the LED-UV Unit fixing screw.
The measurement point and adjustment value are specified
in the step 5.
8. Perform the assembly by reversing the disassembly procedure.
Loosen
2.0 mm
Maintenance Manual > Adjustment > Mechanical Adjustment > LED-UV Unit Height Adjustment
Model UJF-3042/FX Issued 2010.08.27 Revised 2011.09.30 F/W ver 1.80 / 1.00 Remark
2.0
Rev.