MIMAKI UJF-3042 - 2011 Mimaki Engineering Co.,Ltd

© 2011 MIMAKI ENGINEERING CO.,LTD. 6.5.1 R.2.0 P.1
1
2
3
4
5
6
7
8
Maintenance Manual > Disassembly and Reassembly > Sensors > X origin sensor
Model UJF-3042/FX Issued 2010.08.27 Revised 2011.09.30 F/W ver --- Remark
2.0
Rev.
6.5.1 X origin sensor
 Working Procedure
1. Turn the main power OFF
2. Remove the following cover:
• PCB Cover
• Rear Cover-under TB
3. Loosen the fixing of the cable and pull out all connectors from
the PCB.
4. Remove the PCB BKT.(It is OK if PCB is attached with it.)
 To turn power off, be sure to turn the main power OFF.
X origin sensor
Rear cover-Under TB
PCB Cover
X origin Sensor
PCB BKT