© 2011 MIMAKI ENGINEERING CO.,LTD. 5.1.9 R.2.1 P.1
1
2
3
4
5
6
7
8
Maintenance Manual > Test > Test Items > UV LEVEL Check
Model UJF-3042/FX Issued 2010.08.27 Revised
2013
.07.18 F/W ver 1.80 / 1.00 Remark
2.1
5.1.9 UV LEVEL Check
Outline
Operates for measuring the amount of light of LED-UV.
Content
1 Align the sensor part of the light checker installed on the measurement jig with the mark on the back right side of
the table.
2 Set the range of the UV light checker to "H".
3 Set the mode to "DHMAX".
4 In JOG mode, set the height of the table to 41.7 mm.
5 Press the [ENTER] key to exit JOG mode.
6 From the [FUNCTION] menu, select [MAINTENANCE] -> [UV LAMP] -> [CHECK UV LEVEL].
7 Point: Select 1, and then press the [ENTER] key.
8 Move the slider back and forth 3 times or more.
9 During UV irradiation, confirm that the cooling fan on the front of the UV lamp unit runs.
10Press the END key to return the slider to the station.
11Confirm the measured value on the light checker.
12If the measured value is less than 400 mW, confirm the position of the sensor for the light checker and the height of
the UV unit, and then perform the measurement again.
13Disengage the MAX hold on the UV light checker, and return the display on the UV light checker to 0.
14Point: Always use Steps 7 through 11, in order, to measure 2 through 8.
15Point: Select ALL = all lamps on for 3 minutes. Confirm that no errors occur and that there are no problems.
16Press the[ END] key several times to exit brightness measurement.
Wear protective eyewear to prevent injury to your eyes.
Sensor part
Take care to prevent misalignment of the
position in the X direction, and upward
movement of the sensor and jig.
Set to "H".
Press the button on the left side several
times until the display on the LCD screen
says "DHMAX".
To Next Page
Loading...
