MIMAKI UJF-3042 - 2011 Mimaki Engineering Co.,Ltd

© 2011 MIMAKI ENGINEERING CO.,LTD. 4.2.13 R.2.0 P.1
1
2
3
4
5
6
7
8
Maintenance Manual > Adjustment > Adjustment Items > SET QUALITY
Model UJF-3042/FX Issued 2010.08.27 Revised 2011.09.30 F/W ver 1.80 / 1.00 Remark
2.0
Rev.
4.2.13 SET QUALITY
 Outline
Setting of the operation mode of user-setting print quality.
 SET QUALITY List of Items
 Work Procedures
1. Select [#ADJUST] -> [SET QUALITY].
2. Select then change the resolution (DPI).
[]/[]: Switch
[ENTER]: Confirms (Next)
[END]: Return
3. Select then change the print quality.
[]/[]: Switch
[ENTER]: Confirms (Next)
[END]: Return
4. Select then change the number of partition passes.
[]/[]: Switch
[ENTER]: Confirms (Next)
[END]: Return
5. Select then change ON/OFF of the High-speed scan.
[]/[]: Switch
[ENTER]: Confirms (End)
[END]: Return
No Item Description
1 Resolution selection 300, 600, 900, 1200
2 Print quality selection NORMAL, FINE, FAST
3 Number of passes selection 2, 4, 6, 8, 12, 16, 18, 24, 32
4 High-speed scan selection ON/ OFF
FUNCTION
#ADJUST <ent>
#ADJUST
SET QUALITY <ent>
#SET QUALITY
X DPI : 300
600
900
1200
#SET QUALITY
QUALITY :NORMAL
FINE
FAST
#SET QUALITY
PASS : 2pass
#SET QUALITY
HIGHSPEED :OFF
ON
 This can be set if the number of partition passes is
not minimum.