MIMAKI UJF-3042 - 2011 Mimaki Engineering Co.,Ltd

© 2011 MIMAKI ENGINEERING CO.,LTD. 4.2.2 R.2.0 P.1
1
2
3
4
5
6
7
8
Maintenance Manual > Adjustment > Adjustment Items > HEAD ADJUST
Model UJF-3042/FX Issued 2010.08.27 Revised 2011.09.30 F/W ver 1.80 / 1.00 Remark
2.0
Rev.
4.2.2 HEAD ADJUST
 Outline
On the drawing with the built-in patterns, the slant and the back and forth positions of each head are checked and
mechanically adjusted.
 Head Adjusting Flow
 [HEAD ADJUST] consists of the slant adjustment and back/forth adjustment.
When either one of the above is adjusted, be sure to check the other. If any adjustment is required,
repeat both of the adjustments alternately until any adjustment is not required on both.
 When the head adjustment is incorrect, be sure to execute the adjustment since it affects other param-
eter adjustments.
Pattern check
Normal?
Pattern print (Slant adjust: Normal)
Yes
Pattern check
Normal?
Pattern print (Slant adjust: Fine)
Pattern check
Normal?
Pattern print (Position adjust) 1, 2
Adjusting (Position adjust: Normal) 1, 2
Adjusting (Slant adjust: Fine)
Adjusted after
Slant adjust?
No
Yes
START
No
Adjusting (Slant adjust: Normal)
Refer to PRINT ADJUST (4.2.1)
Head Slant
Adjustment
(
refer to Page2)
Yes
No
Yes
No
Head Back/Forth
Adjustment (
refer to
Page7)