MIMAKI UJF-3042 - 2011 Mimaki Engineering Co.,Ltd

© 2011 MIMAKI ENGINEERING CO.,LTD. 6.2.3 R.2.0 P.2
6.2.3 Pump Head
1
2
3
4
5
6
7
8
 Tube replacing/Pump head assembling procedure
4. Pull the catch part of Pump Cover frontward to remove the
Pump Cover.
5. After the replacement of Pump Tube, put the tube between roll-
ers in parallel, and insert the Pump Roller into the main unit.
6. Assemble the pump cover.
7. Perform Pump tube aging.
Rotate the pump with an electric screwdriver for one minute
and more.
8. Attach the pump head to the station Assy.
Attach it in the reverse procedures of the Step 3.
Pump Tube
 Apply the silicon grease, which is included in the
Maintenance Tube Set, to the Pump Roller and
Pump Tube. (approx. half a bag for one pump)
In the following case, the assembling is not accepted.
 The hook of Pump Cover is not firmly engaged
with the base.
 Be sure to perform this before attaching.
Otherwise, it may cause power swing of the
pump motor or abnormal noise.
Maintenance Manual > Disassembly and Reassembly > Ink-related Parts > Pump Head
Model UJF-3042/FX Issued 2010.08.27 Revised 2011.09.30 F/W ver --- Remark
2.0
Rev.