MIMAKI UJF-3042 - 2011 Mimaki Engineering Co.,Ltd

© 2011 MIMAKI ENGINEERING CO.,LTD. 7.1.1 R.2.0 P.1
1
2
3
4
5
6
7
8
Maintenance Manual > Troubleshooting > Details on Errors and Malfunctions > Concerning Errors and Malfunctions
Model UJF-3042/FX Issued 2010.08.27 Revised 2011.09.30 F/W ver 1.80 / 1.00 Remark
2.0
Rev.
7.1.1 Concerning Errors and Malfunctions
 Outline
This chapter describes the troubleshooting for UJF-3042/FX.
 Rough Identification of the Source of the Trouble
At the beginning of troubleshooting, it is necessary to identify roughly which functions the trouble relates to.
Problems can be roughly classified into those that relate to the printer itself and those that involve the connecti
on
between the printer and the host computer.
 Problems with the printer itself
The cause of the trouble can be identified by executing appropriate functions or using test functions.
 Problems concerning the connection to the host computer
Hardware: Broken wire or faulty contact of cables
Software: Transmission by improper application setting
In the standard setting of UJF-3042/FX, priority is given to the host computer.
Check the settings on the host computer to see if there is any improper parameter setting.
START
Rough identification of error source
Execute appropriate functions or use test func-
tions of UJF-3042/FX
Precautions in maintenance
Refer to 7.1.2 List of Error Messages.
Troubles on the host computer side
If this troubleshooting cannot correct the trouble, check to see if the same trouble occurs with another
host computer (if possible).
Do the
above functions operate
normally?
No
Is there error message?
Yes
No
Yes
Trouble due
to the print quality?
Yes
No
Refer to 7.2 Detailed Methods of Coping with the Malfunctions
(Add information sequentially)