MIMAKI UJF-3042 - 2011 Mimaki Engineering Co.,Ltd; Adjustment of Table Flatness

© 2011 MIMAKI ENGINEERING CO.,LTD. 4.3.1 R.2.0 P.2
4.3.1 Adjustment of theTable Flatness
1
2
3
4
5
6
7
8
4. Place the Thickness gauge under the carriage (see the figure).
5. Loosen the Fixing screws of the Up/Down cam.
Loosen the cap bolt located in the side hole of the UV protec-
tion plate, inserting a wrench into the hole.
6. Adjust the height.
Adjust the table height so that the gap between the height
adjustment jig placed in the step 4 and carriage is cleared.
1), Loosen the red circled Lock Nut
and rotate the cap bolt to
move the Up/Down cam back and forth, and fine adjust the
table height.
2),Tighten the Lock Nut when the height is adjusted.
3),Tighten the Fixing screws of the Up/Down cam loosened in
the step 5.
4),Confirm that there is no gap between the Up/Down cam and
Roller.
7. Adjust all the four points specified in the step 3 following
the
above procedure.
8. Reattach the cover.
1.5mm
The Thickness gauge should be placed in the same
position of the carriage, for all the adjusting points.
If it varies, the carriage may be inclined.
Side of UV protection plate
(same between right and
left sides)
Fixing screws of the
Up/Down Cam
Front
Rear
Up/Down cam
Roller
Up/Down cam
Roller
 The inclined surface of the Up/Down cam should be
always in contact with the Roller during adjustment.
 It is ideal to move the Up/Down cam with your
hands to keep it in absolute contact with the Roller.
 Be careful not to deform the carriage by excessive
pressure.
Maintenance Manual > Adjustment > Adjustment Items > Adjustment of theTable Flatness
Model UJF-3042/FX Issued 2010.08.27 Revised 2011.09.30 F/W ver 1.80 / 1.00 Remark
2.0
Rev.