MIMAKI UJF-3042 - 2011 Mimaki Engineering Co.,Ltd

© 2011 MIMAKI ENGINEERING CO.,LTD. 6.2.6 R.2.0 P.2
6.2.6 Cartridge Guide Assy.
1
2
3
4
5
6
7
8
6. Remove the Cap Nut, and pull of the Ink Tube..
7. Remove the Ink Slot Guide GASS(steel plate).
Screw : P3x6SMW x3
8. Remove the two screws that fix the Ink Slot Guide BKT1(steel
plate).
9. Remove the Cartridge Guide(Group1).
The Ink Slot Guide BKT1(steel plate) should be kept attached.
10. Remove the two screws that fix the Ink Slot Guide BKT2(steel
plate).
11. Remove the Cartridge Guide(Group2).
The Ink Slot Guide BKT2(steel plate) should be kept attached.
 Take care not to stain any object by ink dripping
and also not to lose the O-ring.
Important notes for the following steps 8 to 11.
The red circles in the above figure indicate the fitting
positions of the resin ribs from the Cartridge Guide
and the plate. Be careful not to break the ribs.
Screw(x2)
Ink Slot Guide
BKT1
Cartridge
Guide(Group1)
Cartridge
Guide(Group2)
Ink Slot Guide
BKT2
Screw(x2)
Maintenance Manual > Disassembly and Reassembly > Ink-related Parts > Cartridge Guide Assy.
Model UJF-3042/FX Issued 2010.08.27 Revised 2011.09.30 F/W ver --- Remark
2.0
Rev.