MIMAKI UJF-3042 - 2011 Mimaki Engineering Co.,Ltd

© 2011 MIMAKI ENGINEERING CO.,LTD. 4.3.1 R.2.0 P.1
1
2
3
4
5
6
7
8
Maintenance Manual > Adjustment > Mechanical Adjustment > Adjustment of theTable Flatness
Model UJF-3042/FX Issued 2010.08.27 Revised 2011.09.30 F/W ver 1.80 / 1.00 Remark
2.0
Rev.
4.3.1 Adjustment of theTable Flatness
 Outline
Adjust the table flatness by adjusting the contacting position between the four Up/Down cams and Rollers under the
table.
 Procedures
1. Remove the following covers: (See6.1.1)
1),Rear Cover TB
2. Raise the table with the up/down key so that LCD indicates
50mm for height.
3. Adjust the four points shown in the left figure.
Move the head with the up, down, right and left keys in
<LOCAL> mode.
(You can start adjustment from any point.)
• The following procedure is shared by four adjusting points.
Rear Cover TB
ORIGIN SET UP
TABLE HEIGHT 25.0
ORIGIN SET UP
300 190
ORIGIN SET UP
300 00
ORIGIN SET UP
00 190
ORIGIN SET UP
00 00
Table
Rear
Front