MIMAKI UJF-3042 - 2011 Mimaki Engineering Co.,Ltd

© 2011 MIMAKI ENGINEERING CO.,LTD. 6.3.2 R.2.0 P.2
6.3.2 Y-axis Motor
1
2
3
4
5
6
7
8
6. Remove the Y Motor Assy from the Y-Motor BKT.
Screw : P4x10SMW x2
7. Loosen a Hexagon Socket Head Screw then remove the pulley
from the motor.
8. Perform the assembly by reversing the disassembly procedure.
Two Screws
Pulley
Hexagon Socket Head Screw
Pay attention to missing of the screw.
Good
Example:
Belt biased to either upper
or lower.
Belt tilted.
Bad
Example:
Bad
Example:
Put it on the pulley center in
parallel.
Put the belt on the center of both pulleys in parallel.
(Acceptable on the upper)
Maintenance Manual > Disassembly and Reassembly > Driving Parts > Y-axis Motor
Model UJF-3042/FX Issued 2010.08.27 Revised 2011.09.30 F/W ver --- Remark
2.0
Rev.