Weight type/plus or minus sign Description
Preset tare, not tared
No display - Test value
- Gross, not tared
Additional weight display, application-dependent
Additional weight display, application-dependent
Additional weight display, application-dependent
Positive value
Negative value
Standstill/zero/batching/moni-
toring
Description
Weight value standstill
The gross weight value is within ±¼ d of zero
Batching mode: ashes when batching is "stopped";
rapid ashing indicates "error status"
Pendeo load cells: Plausibility monitoring; the aver-
age deviation of the individual load cells is calcula-
ted
Pendeo load cells: Temperature monitoring; 1–n
load cells above or below permissible temperature
Symbols/mass unit Description
Value not permissible in legal metrology (e.g., 10x
resolution, deactivated load cell)
R1 Range 1
R2 Range 2
R3 Range 3
WP A Weighing point A
WP B Weighing point B
WP C Weighing point C
WP D Weighing point D
Max Maximum capacity (weighing range)
Min Minimum weight
Only if W&M is selected: Border around inadmissible
decimal place.
t, kg, g, mg, lb, oz These mass units are available.
Process Controller Maxxis 5 PR 5900 2 Commissioning
Minebea Intec EN-10
To Next Page
Loading...
