Minebea Intec PR5900 - Page 162

[Parity]
Parity check for detecting errors during data transmission.
Selection: no parity, odd parity, even parity
[Stop bits]
Units for transmission protocols.
Selection: 1 stop bit, [2 stop bits]
[Default] soft key
Settings are reset to factory settings.
4.7.6.2 Parameters
In this menu item, the parameters of the SBI scale weighing electronics are congured.
Accessible via MENU - [Operating] - [System setup] - [Weighing points] - [Weighing
point x] - [Parameters] .
WP-D Max -------?? d= -------??
no values from scale
Weighing points @admin
Weighing point A
Weighing point B
Weighing point C
Weighing point D
Internal weighing point
Pendeo Truck
xBPI scale
SBI scale
Parameters
WP-D Max -------?? d= -------??
no values from scale
Weighing points @admin
Weighing point D
Settings locked
W&M
Max
Scale interval
Minimum weight
SBI scale
none
1000 kg
1
0 d
Default Save
[Settings locked]
The weighing point settings and assignment can only be viewed as if the
corresponding CAL switch were closed; see Chapter 2.7.1.
3. Press the [Save] soft key to save the settings.
1. In this case: Select [Weighing point D] with [SBI scale] and press the [Parameters] soft
key.
A selection window opens.
2. Select and conrm the individual parameters.
Process Controller Maxxis 5 PR 5900 4 System setup
Minebea Intec EN-160