Minebea Intec PR5900 - Page 164

Weighing point D @admin
Weighing point not assigned
Save
Weighing point D @admin
Weighing point not assigned
Save
Not assigned
Internal weighing point
Liquid counter
User scale
xBPI scale
SBI scale
Pendeo Truck
Pendeo Process
PR-Net weighing point
Mettler-Scale
SMA scale
4.7.7.1 Interface (serial)
In this menu item, the parameters of the serial interface of the digital weighbridge load
cell Pendeo
®
Truck are congured.
Accessible via MENU - [Operating] - [System setup] - [Weighing points] - [Weighing
point x] - [Interface] .
1. Conrm [Weighing point].
A selection window opens.
2. Select and conrm [Pendeo Truck].
3. Press the [Save] soft key to save the settings.
If a scale has not yet been connected, the message "scale not ready" appears.
WP-D Max -------?? d= -------??
read config failed
Weighing points @admin
Weighing point A
Weighing point B
Weighing point C
Weighing point D
Internal weighing point
Internal weighing point
xBPI scale
Pendeo Truck
Parameters Calib Units
The weighing electronics are now assigned to the weighing point.
Process Controller Maxxis 5 PR 5900 4 System setup
Minebea Intec EN-162