Minebea Intec PR5900 - Page 84

[use DHCP]
If ☑ is checked (default setting: DHCP selected), the server automatically allocates the
IP address, subnet mask, and default gateway.
If no checkbox ☐ is ticked, the settings for the [IP address], [Subnet mask] and
[Default gateway]must be dened in conjunction with the responsible system
administrator.
Network parameters @admin
HW address
Host name
use DHCP
IP address
Subnet mask
Default gateway
Remote access
Web server enabled
VNC access enabled
VNC client
VNC password
00:90:6C:27:FF:07
PR5900-27FF07
172.24.20.111
255.255.240.0
172.24.16.1
255.255.255.255
********
Default Save
[Web server enabled]
If the checkbox ☑ is ticked, the device website can be used.
[VNC access enabled]
If the checkbox ☑ is ticked, the device can be operated via VNC.
[VNC client]
This address can be used to allow access to the interface.
Address Access
172.24.21.101 only from client machine with this address.
172.24.21.255 from any client with address within range
172.24.21.1…172.24.21.254.
255.255.255.255 from a client with any address
[VNC password]
If a password is entered (max. 8 characters), this password must be entered in the
VNC client to access the interface.
[Default] soft key
- resets the host name to PR5900-XXXXXX, where XXXXXX stands for the last
3 bytes of the hardware address (MAC ID).
- sets [use DHCP] to active.
- sets the IP address to 0.0.0.0.
- sets the subnet mask to 0.0.0.0.
- sets the default gateway to 0.0.0.0.
- sets the VNC client to 255.255.255.255.
Process Controller Maxxis 5 PR 5900 4 System setup
Minebea Intec EN-82