MR TAPCON - Page 101

8 Operation
Maschinenfabrik Reinhausen GmbH 2020 1013587317/21 EN TAPCON
®
Settings
Parameters
Screensaver
Name Value
Screensaver On
Screensaver waiting time 15min
Dimming On
Dimming waiting time 3min
Brightness dimming 50%
Home
Events
Information
Recorder
Settings
EN
CHANGE
REBOOT
admin 30.01.2020 10:32
Figure80: Setting the screensaver
1. Go to Settings > Parameters > System > Screensaver.
2. Select the desired parameter.
3. Set the desired parameter.
4. Press the Accept button to save the modified parameter.
Screensaver
If you activate this function, the device fully switches off the display when the
adjustable waiting period has expired if no key is pressed. The display
switches on again if you press any key.
Deactivating the screensaver has a negative impact on the service life of
the display. Maschinenfabrik Reinhausen recommends that you activate the
screensaver and set a waiting period of 15 minutes.
Screensaver waiting time
You can use this parameter to set the screensaver waiting time.
Dimming
When you activate this function, the device reduces the brightness of the
display when the adjustable waiting time has expired if no key is pressed.
The device then switches back to full brightness when you subsequently
press any key.
If the screensaver and brightness dimming are activated, you have to press
any key twice in order to reactivate the display at full brightness.
Dimming waiting time
You can use this parameter to set the dimming waiting time.