MR TAPCON - Set up Automatic Logout

8 Operation
Maschinenfabrik Reinhausen GmbH 202090 3587317/21 ENTAPCON
®
Remote behavior
You can use this parameter to select the behavior of the device in remote
operating mode. Depending on the device configuration, you can set the re-
mote behavior as follows:
▪ Through the visualization (optional)
▪ By setting the digital inputs (optional)
You can select the following settings:
Setting Description
Hardware only The device accepts commands through digital inputs.
SCADA only The device accepts commands via SCADA.
Hardware and SCADA The device accepts commands via digital inputs and
SCADA.
Table19: Selecting remote behavior
USB interface
You can use this parameter to deactivate the USB interface. You can select
the following options:
▪ On: USB interface is activated
▪ Off: USB interface is deactivated
8.2.2 Set up automatic logout
You can change the settings so that the device of a logged-in user automati-
cally logs the user out after a certain period of inactivity.
These settings apply to all users. If you have activated the Auto login
[►Section 8.26.3, Page 243] function for a user, then this user will not be
automatically logged out.