MR TAPCON - Setting the Screensaver

8 Operation
Maschinenfabrik Reinhausen GmbH 2020100 3587317/21 ENTAPCON
®
Syslog server
You can use this parameter to set the IP address of the syslog server.
Syslog server port
You can use this parameter to set the port of the syslog server.
Reconnect delay time
You can use this parameter to determine how long the device will wait be-
fore it attempts to reconnect after the connection has been interrupted earlier
or a syslog message could not be transmitted (only for TCP or TLS).
Device designation
You can use this parameter to set the device designation that the device will
be identified with on the syslog server.
Severity level
You can set which syslog messages the device will send. You can also acti-
vate or deactivate messages for each severity level.
Severity level Description
Emergency The system is unusable.
Alert Immediate intervention required.
Critical Critical state
Error Error state
Warning Warning state
Notice Notice state
Info Information state
Debug Debug state
Table23: Severity levels
8.7 Setting the screensaver
In order to increase the service life of the display on the front panel of the
device, you can activate and set a screensaver. The following functions are
available for this purpose:
▪ Switching off the display
▪ Dimming the brightness of the display