MR TAPCON - Installing the Individual Components on a Cap Rail

6 Mounting
Maschinenfabrik Reinhausen GmbH 202054 3587317/21 ENTAPCON
®
4. Slide device into flush control panel frame and secure.
Figure36: Securing device
5. Close cover of flush control panel frame.
Figure37: Closing cover
6.5 Installing the individual components on a cap rail
If you want to install individual components on a cap rail, you must install the
cap rail in a control cabinet.
If there are operating elements in your control cabinet, you must take suit-
able measures (e.g. covering) to ensure that the device components cannot
be touched.