MR TAPCON - Displaying Event Memory

8 Operation
Maschinenfabrik Reinhausen GmbH 2020 2393587317/21 EN TAPCON
®
Settings Events Limit value U<
Name
Description
Remedy
Category
Limit value U<
Value has fallen below the limit value for undervoltage U<.
Check the current operating conditions of the transformer and the set U<
parameters.
Cancel Accept
Warning
Report
Save
Multi-set
High active
Acknowledgeable
Blocking
Home
Events
Information
Recorder
Settings
EN CHANGE REBOOTadmin 06.04.2020 09:27
Figure169: Configuring events
To configure an event, proceed as follows:
1. Go to Settings > Events.
2. Select the event to be changed in the list.
3. Select the desired options.
4. Press the Accept button to save the change.
8.25.3 Displaying event memory
Past events are stored in the event memory. The following information is dis-
played:
Column Description
# Consecutive number of events
No. Event number for clear identification
Event category:
▪ Error (red)
▪ Warning (yellow)
▪ Info (gray)
Event Event text
Time Date and time of event (DD-MM-YYYY, HH:MM:SS/ms)
/
Event coming/going:
Event coming
Event going
Table85: Event memory
To call up the event memory, proceed as follows:
1. Go to Events.
2. Press the Log button.