MR TAPCON - Import;Export Manager; Exporting Data

8 Operation
Maschinenfabrik Reinhausen GmbH 2020 2513587317/21 EN TAPCON
®
8.28 Import/export manager
The device is equipped with an import/export manager, which can be used
to export and import various data.
To transfer the data, the following options are available:
Option Description
USB Data transfer via USB port on rear of CPU I assembly.
PC Data transfer via PC using web-based visualization.
Table90: Data transfer options
8.28.1 Exporting data
The device stops logging the measured value recorder data for the duration
of the export.
You can export the following data from the device, depending on your device
configuration:
Option Description
System image Complete image of the system (software and configuration). If you
are using the option "with history", all of the event memory entries
are also exported.
System config-
uration
System configuration
Customer pro-
gram
Customer program export (TPLE).
Event memory All event memory entries.
Recorder Measured value memory export.
Parameter list Parameter list with descriptive text and values (min, max, current).
Event list Complete list of all possible events.
SCADA config-
uration
Control system configuration (e.g. ICD file for IEC61850).
Operating In-
structions
Operating instructions, protocol specifications.
Settings Configuration of parameters and events.
Data point con-
figuration
Data point configuration of the control system.
Sensor bus de-
vice descrip-
tion
Sensor description of the sensors for MR sensor bus that have
been created with the sensor editor.
Service data Device data for support through the Maschinenfabrik Reinhausen
GmbH Technical Service department