MR TAPCON - Page 174

8 Operation
Maschinenfabrik Reinhausen GmbH 2020174 3587317/21 ENTAPCON
®
Settings
Parameters
Compensation
Name Value
Compensation method R&X compensation
Ohmic resistance load 0.0Ohm/m
Inductive resistance load 0.0Ohm/m
Length of line 0.00m
Voltage increase 0.0%
Voltage limit value 0.0%
Home
Events
Information
Recorder
Settings
EN
CHANGE
REBOOT
admin 03.02.2020 08:09
Figure119: Compensation
1. Go to Settings > Parameters > Grid > Compensation.
2. Select the desired parameter.
3. Set the desired parameter.
4. Press the Accept button to save the modified parameter.
Compensation method
You can use this parameter to set the compensation method.
Ohmic resistance load
You can use this parameter to set the ohmic resistance load.
Inductive resistance load
You can use this parameter to set the inductive resistance load.
Length of line
You can use this parameter to set the length of line.