6 Functions Common to More Than One Operating Mode
88 SRM-3006 Narda
To change the settings:
1. Press the Change Settings softkey and then change the settings.
2. Press the Back to Axis softkey (highlighted in yellow) to return to
measurement mode.
To finish isotropic measurement:
⇒ Press the Axis softkey and select Single Axis.
6.7 Adjusting the Y axis
Spectrum • Display • Y-Scale...
Level Recorder • Display • Y-Scale...
Scope • Display • Y-Scale...
There are two ways of adjusting the Y axis:
• Manual adjustment of Y axis scaling and reference point
• Automatic adjustment of Y axis
Adjusting the Y axis manually
You can change the scaling as well as the reference point of the Y axis.
Changes you make are applied immediately.
To change the Y axis scaling:
1. Press the Y-Scale Range softkey.
2. Use the rotary control to highlight the desired value.
ª The change is applied to the display immediately.
3. Press the OK key or the ESC key.
To change the Y axis reference point:
1. Press the Y-Scale Ref softkey.
2. Use the rotary control to highlight the desired value.
ª The change is applied to the display immediately.
3. Press the OK key or the ESC key.
Adjusting the Y axis automatically
⇒ Press the Y-Scale Auto softkey.
ª The Y axis is adjusted automatically.
In this case, the scaling (Y-Scale Range) is set to 100 dB and the reference
point (Y-Scale Ref) is the same as the measurement range (MR+0 dB).
To Next Page
Loading...
Need help?
General
