NARDA SRM-3006 - Basic Settings; Selecting the Display Mode; Activating the Beeper

7 Safety Evaluation Mode
96 SRM-3006 Narda
7.2 Basic settings
This section describes the settings that are identical for both display modes
Table and Bar Graph.
7.2.1 Selecting the display mode
Safety Evaluation • Display • Views
Two display modes are available:
• Table (see page 99)
• Bar Graph (see page 103)
To switch the display mode:
1. Press the Display softkey.
2. Press the Views softkey.
ª The Select View window opens.
3. Use the rotary control to highlight a view and press the OK key:
–Table
– Bar Graph
ª The selected view will be displayed.
Note: Pressing the ESC key returns you to the top menu level in the
measurement screen. (Press the MENU key to return to the Main
menu.)
7.2.2 Activating the beeper
Main Menu • Settings • Beep on new Maximum
A new maximum level can also be indicated by a beeper. To do this, you
must activate the Beep on new Maximum function in the main menu under
Settings.
To activate the beeper:
⇒ See Editing device-specific settings on page 57.