NARDA SRM-3006 - Performing Device Diagnosis

5 The Main Menu
60 SRM-3006 Narda
To reset all device settings:
1. Open the Service menu (Main Menu • Settings • Service Menu) and
press the Factory Settings softkey.
2. Press OK to confirm the reset.
5.2.6 Performing device diagnosis
Main Menu • Settings • Service Menu
This menu allows you to check the display and to monitor some basic device
data.
⇒ Press the Service Menu softkey.
ª The Service Menu is displayed.
To check the display:
⇒ Press the Display Test softkey.
ª The basic colors red, green and blue are displayed in turn.
The test stops after three cycles.
⇒ Press the ESC key to end the test immediately.
To display the device diagnostics:
⇒ Press the Device Diag softkey.
ª A list of some basic data is displayed.
Note: The displayed data is intended primarily for servicing purposes.
Table 11: Description of Device Diagnostics list
Information Description
Mainboard Temperature Temperature of main circuit board
RFboard Temperature Temperature of RF circuit board
Battery Voltage Actual battery voltage
Battery Capacity Remaining battery capacity
Buffer Battery Voltage Internal buffer battery voltage
Free Memory Free memory space in megabytes, absolute
Free Memory in Percent Free memory space in percent, relative
Device Calibration OK Indicates whether device calibration is still valid or not
Operating Hours Counter Number of hours of operation so far