NARDA SRM-3006 - Displaying the Marker Data on the Measurement Screen

6 Functions Common to More Than One Operating Mode
82 SRM-3006 Narda
6.5.3 Displaying the marker data on the measurement
screen
If you activate the Marker function (Keep Marker = On), the frequency and
measured value corresponding to the active marker are displayed in the
upper status bar instead of the GPS data.
Figure 19: Display of marker data in the upper status bar.
To activate the display function:
✓ The Marker menu is active.
1. Press the Keep Marker A or Keep Marker B softkey until On is shown.
(If you select the other marker, the Keep Marker softkey changes to
reflect the choice of the new marker.)
2. Press the ESC key to return to the measurement screen.