NARDA SRM-3006 - Saving and loading setups

5 The Main Menu
66 SRM-3006 Narda
5.4.2 Starting a measurement routine
Main Menu • Measurement Routines • Start Routine
⇒ Use the rotary control to highlight the desired measurement routine and
press the Start Routine softkey or press OK.
ª The measurement routine starts.
5.5 Saving and loading setups
Main Menu • Setups
You can use this menu to save all the settings as a setup or recall and load
setups that you have saved previously.
Note: Setups can only be created on the device itself. You cannot create
setups on a PC. In contrast, you can only delete setups using the PC
software. You cannot delete setups on the device itself.
5.5.1 Saving settings as a setup
Main Menu • Setups • Save Setup
1. Make the desired settings on the device.
2. Switch to the Main Menu • Setups menu and press the Save Setup
softkey.
ª The entry box opens.
Note: You can also save a setup directly from an operating mode. This
function is found in the Display menu of the operating mode.
3. Enter a suitable name and press OK to confirm your entry.
ª The settings are saved as a new setup and displayed in the overview
bar.
5.5.2 Loading settings from a setup
Main Menu • Setups • Recall Setup
⇒ Use the rotary control to highlight the desired setup and press the
Recall Setup softkey or the OK key.
ª The settings saved in the selected setup will be loaded and the
display switches to the measurement screen.