6 Functions Common to More Than One Operating Mode
Narda SRM-3006 83
6.5.4 Zooming to marker
The Zoom to Marker function allows you to display an enlargement of a
section around the current marker position. The marker position is used
here as the center frequency of the zoomed display, and the frequency limits
are adjusted to suit.
To zoom to the marker:
1. Set the marker to the desired position.
2. Press the Zoom to Marker softkey.
ª The display is adjusted accordingly.
3. Press Zoom to Marker again to further enlarge the display.
To reset the display to the full frequency range:
1. Exit from the Marker menu.
2. Press the Set Freq softkey until Fmin & Fmax is displayed.
3. Press the Fspan softkey and then select Full Span.
ª The full frequency range is displayed once more.
To Next Page
Loading...
