16 Remote Control
176 SRM-3006 Narda
16.1 About remote control
Remote control of the SRM-3006 using a suitable program (e.g. standard
terminal emulators such as Hyperterminal) is particularly suitable for exotic
applications and is therefore an alternative to operation using the Narda PC
software applications. Since all device functions can be remote-controlled,
the full potential of the SRM-3006 can also be realized in remote operation.
Note: Because the software for the SRM-3006 is being constantly
developed and updated, there is a separate document that covers
remote control. This contains the individual remote control
commands and some example programs along with other
information. The latest version of the document in PDF format can be
obtained from Narda Safety Test Solutions on request. Directly
requesting the document in this way ensures that you will receive the
remote control instructions that correspond to the firmware you are
using.
16.2 Connecting to the PC
Notes on connecting the SRM-3006 to the PC are found under Connecting
to the PC on page 172.
To make the connection:
1. Connect the SRM-3006 and the PC together using one of the options
described.
2. Start the application for controlling and managing the PC interface and
set the following interface parameters:
3. Switch on the SRM-3006, open the Main Menu / Device Settings and
set Remote Interface to Optical or USB as appropriate.
Parameter Setting
COM Port Optical or USB, as selected by connection made (item 1 above)
Baud rate 115200 Baud
Start bits 1
Data bits 8
Stop bits 1
Parity None
Handshake None (the SRM-3006 does not support any software handshake)
To Next Page
Loading...
