NARDA SRM-3006 - Activating; deactivating remote control; Syntax rules for remote control commands

13 Measurement Data Memory
Narda SRM-3006 165
13.4.3 Changing the comment modes
Main Menu • Memory • Comment
⇒ Press the Comment softkey.
ª The Comment dialog is displayed.
Comments can be added to data sets or screenshots. In both cases the
comment mode and the default comment text can be set individually.
Following table shows the available comment modes:
To change the comment mode:
1. Use the rotary control to select Dataset Comment Mode or
Screenshot Comment Mode and press OK.
2. Use the rotary control to change the mode and press OK.
To change the default comment text:
1. Use the rotary control to select Standard Data Set Comment Text or
Standard Scr.shot Comment Text and press OK.
ª The text editor opens.
2. Enter the default text and press OK.
ª This text will be used when Standard Text is set as Comment Mode.
When Individual Text is set, the entered text is suggested in the
editor and can be complemented or overwritten.
Table 38: Comment modes
Mode When saving a dataset or a screenshot ...
No Comment ... no comment can be added.
Standard Text ... the text saved in Standard Data Set Comment Text or
Standard Scr.shot Comment Text is added as a comment.
Individual Text ... the text saved in Standard Data Set Comment Text or
Standard Scr.shot Comment Text is displayed in the text
editor and can be edited.
Voice Comment ... a voice comment can be added (voice comment is available
for datasets only).