NARDA SRM-3006 - Handling Battery Packs

Narda SRM-3006 29
3.3.2 Handling battery packs
• Do not drop, damage, or disassemble the battery packs.
• Only recharge the battery packs in the way described in this operating
manual.
• Do not expose the battery packs to very high temperatures for an
extended period of time either separately or inside the device.
• Do not leave discharged battery packs in the device for an extended
period of time.
• Do not store the battery packs for longer than six months without
recharging them in the meantime.
Replacing the battery pack:
1. Undo the fixing screw (1) in the lid of the battery compartment.
2. Pull out the battery pack using the tab (2).
3. Hold the tab on the new battery pack and slide the battery pack into the
compartment.
4. Replace the lid of the battery compartment and do up the fixing screw
(finger tight).
Note: If the old battery pack is no longer required, do not simply throw it
away with the normal trash. Dispose of it according to the regulations
applicable in the country of use (also refer to Proper disposal
on page 22).
1
2