NARDA SRM-3006 - Activating the Beeper; Basic Settings; Selecting the Center Frequency (Fcent); Setting the Resolution Bandwidth (RBW)

9 Level Recorder Mode
120 SRM-3006 Narda
9.2.1 Activating the beeper
Main Menu • Settings • Beep on new Maximum
A new maximum level can also be indicated by a beeper. To do this, you
must activate the Beep on new Maximum function in the main menu under
Settings.
To activate the beeper:
⇒ See Editing device-specific settings on page 57.
9.3 Basic settings
This section describes the basic settings. If these settings are identical in
more than one operating mode, a cross-reference will indicate the relevant
section in Chapter 6 Functions Common to More Than One Operating
Mode on page 69 where the setting is described.
9.3.1 Selecting the center frequency (Fcent)
Level Recorder • Fcent
1. Press the Fcent softkey.
2. Use the arrow keys to select a decimal digit and then change the
value using the rotary control.
3. Press the OK key to set the value.
9.3.2 Setting the resolution bandwidth (RBW)
Level Recorder • RBW
⇒ See Setting the resolution bandwidth (RBW) on page 71.
9.3.3 Setting the video bandwidth (VBW)
Level Recorder • RBW • VBW
⇒ See Setting the video bandwidth (VBW) on page 71.