NARDA SRM-3006 - Overview of functions common to more than one operating mode

6 Functions Common to More Than One Operating Mode
70 SRM-3006 Narda
6.1 Overview of functions common to more
than one operating mode
The table below indicates the operating modes that use the functions
described in this chapter.
The menu paths shown in gray immediately below the section heading
indicate the operating modes and sub-menus where the function described
can be found.
Screenshots, where used, only serve to illustrate the function. As a rule, the
settings described apply in the same way in the other operating modes
although the display on the screen may not be the same as the screenshot
used in this manual.
Table 19: Functions and operating modes
Function
Safety
Evaluation
Spectrum Level
Recorder
UMTS Scope
Resolution bandwidth (RBW)
Video bandwidth (VBW)
(x) x x –
1)
x
Meas. Range xxxxx
Result type xx(x)xx
2)
Marker x
3)
x––x
Axis xxxxx
Y- S c a l e x
3)
xx–x
Unit xxxxx
Noise Thresh. x–xx–
Spatial AVG xxx––
x = identical in all these modes, described in this chapter
(x) = present but not identical (description given in the chapter covering the operating mode)
– = not present in this operating mode
1) Fixed at 3.84 MHz
2) Act or Max/Avg/Min selected automatically depending on the settings
3) For Bargraph only