5 The Main Menu
68 SRM-3006 Narda
5.5.5 Changing the switch on behavior
Main Menu • Setups • Power on
Main Menu • Setups • Mark Power on Setup
You can specify the settings to be used by the device when it starts up after
being switched on:
• Last Settings: The settings in use at the time the device was last
switched off will be used.
• Power On Setup: The setup marked in the Setups menu as the
Power on Setup will be used.
To start up using the settings last used:
⇒ Press the Power on softkey until Last Settings is shown (toggle
function).
ª The settings in use at the time the device was last switched off will be
used when it is next switched on.
To start up using a selected setup:
1. Press the Power on softkey until Power On Setup is shown (toggle
function).
2. Use the rotary control to highlight the desired setup and press the
Mark Power on Setup softkey.
ª The selected setup is marked in the list (‹‹...››) and will be loaded the
next time the device is switched on.
To Next Page
Loading...
