NARDA SRM-3006 - Performing a Coverage Measurement; Using Noise Suppression (Noise Thresh.)

11 UMTS Mode
142 SRM-3006 Narda
11.5 Performing a coverage measurement
A coverage measurement determines the ratio of the pilot signal to the
analog value.
⇒ Press the Evaluation softkey, then press the Ratio Pilot / Analog
softkey.
ª The pilot to analog ratio is displayed in the right hand column.
Figure 29: UMTS mode with display of Pilot / Analog.
11.6 Using noise suppression (Noise Thresh.)
UMTS • Meas. Range • Noise Thresh. / Noise Suppr.
⇒ See Noise suppression (Noise Thresh.) on page 90.