NARDA SRM-3006 - About remote control; Connecting to the PC

13 Measurement Data Memory
164 SRM-3006 Narda
To start storing values immediately:
3. Press the Start Now softkey.
ª Automatic storage is activated.
The screen displays the view of the operating mode previously
selected. The info line shows Time Controlled Storing and the
remaining recording time (duration).
To start storing at the specified time:
4. Press the Prog Start softkey.
ª Automatic storage is activated.
ª The screen displays the view of the operating mode previously
selected. The info line shows Time Controlled Storing and the
remaining time until the start of recording. Storing starts when the
countdown reaches 0.
To stop storing:
⇒ Storing stops automatically when the specified duration has elapsed. To
stop storing values before this, press the Stop softkey.
⇒ The operating mode is again displayed normally. You can view the stored
measurement values from the Memory menu (see Viewing data sets
on page 159).