NEC NEAX 2000 - Page 104

CALL FORWARDING-ALL CALLS
CALL FORWARDING-ALL CALLS-D
term
CALL FORWARDING-ALL CALLS-OUTSIDE
– 84 –
A2076-10
HARDWARE REQUIRED
D
term
and DLC card if required
DESCRIPTION DATA
•
(1)
(2)
Y=0
Incoming Trunk Route No. + Outgoing
Trunk Route No. assigned by CM35
Y=05
0: Allow
Specify the setting method for Call For-
warding-All Calls-Outside.
(1)
(2)
222
0 : The feature is set when the station
goes on hook/when receiving Ser-
vice Set Tone (ORT time out)
1 : The feature is set when receiving
Service Set Tone (ORT time out)
Assign whether or not an extension can
set Call Forwarding-All Calls-Outside by
entering only a trunk access code.
(1)
(2)
386
0 : Restrict
1 : Allow
Assign whether or not the system should
check the trunk restriction class of the for-
warded station during a Call Forwarding-
All Calls-Outside.
(1)
(2)
387
0 : Call forwarding All Calls-Outside
follows setting station class
1 : No check
Provide Call Forwarding feature with each
tenant as per incoming call type.
•
•
•
(1)
(2)
Y=23 Internal Call or ATT assisted Call
Y=24 C.O. Incoming Call
Y=25 Tie Line Incoming Call
00-63: Tenant No.
1 : Call Forwarding
Select the Dial Tone on setting Call For-
warding-All Calls.
•
(1)
(2)
Y=2
13: Dial Tone on Setting Call Forward-
ing-All Calls
0 : Special Tone
1 : Dial Tone
CM48
END
CM36
A
CM08
CM65
INITIAL