STATION HUNTING-TERMINAL
– 475 –
A2463-10
STATION HUNTING-TERMINAL
PROGRAMMING
DESCRIPTION DATA
To set up each Station Hunting group, as-
sign station numbers, one by one, as
shown below.
1st Operation (1) Station A
(2) Station B
2nd Operation (1) Station B
(2) Station C
Assign the pilot station to required station
number within the Hunting group.
For the member stations, set the data to
“0”.
NOTE: The maximum number of sta-
tions that can be included on one
Station Hunting group is 60 in-
cluding the Pilot Station.
And there is no limit to the num-
ber of Terminal Hunt groups with-
in the system.
•
(1)
(2)
•
(1)
(2)
Y=0
X-XXXXXXXX: Station No. to be in-
cluded in Station Hunt-
ing Group
X-XXXXXXXX: Another Station No. to
be included in the
Same Hunting Group
Y=1
X-XXXXXXXX: Station No.
0 : Member Station
1 : Pilot Station
Allow or restrict the ability to set Station
Hunting-Terminal for a station with Do Not
Disturb set.
(1)
(2)
240
0 : Allow
1 : Restricted
START
END
CM18
CM08
To Next Page
Loading...
